1.1Cast a zinc alloy body
Pressure die casting forms both blade plates and the coupling column as one piece. The cast side flanges guide the fastener elements as the slider travels.
Generated automatically. Not reviewed by a person. Not legal advice or an opinion.
Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
Pressure die casting forms both blade plates and the coupling column as one piece. The cast side flanges guide the fastener elements as the slider travels.
A rivet passes through a hole in the spring strip and a through-hole in the pad. The rivet clamps one end of the strip, and the free end presses over the pull shaft.
Two raised rails on the upper blade plate form a slot that receives the rear end of the spring strip. Crimped rail ends hold the strip in place, and its forward end captures the pull shaft in a transverse saddle.
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
A slide fastener joins the longitudinal edges of a removable sail cover, with each fastener tape sewn to a reinforced fabric hem. Upper and lower blade plates of an aluminum-alloy slider body straddle the fastener elements, and a coupling column separates the two incoming rows. A spring tongue seats in a groove in the coupling column and holds the shaft of an elongated pull against the upper blade plate. The elongated pull provides a grip for a gloved hand as the blade plates guide the rows together or apart.
A formed round-wire torsion spring serves as the elastic member on the upper blade plate. A transverse pin supported by two bosses carries the spring coil, and one spring leg seats in the insertion groove in the coupling column. The other leg presses the pull shaft into a transverse cradle on the upper blade plate. The spring leg deflects as the shaft enters the cradle and returns over it, leaving the shaft free to rotate.
Precipitation-hardening stainless steel forms the upper blade plate, lower blade plate, and coupling column as a single investment casting. Finish machining sets the guide passage dimensions and cuts the spring insertion groove in the column, and an aging treatment provides an average column hardness above 100 HV. A formed leaf spring seats in the groove and spans the pull shaft where it rests against the upper blade plate. The shaft pivots under the spring while the blade plates guide the fastener elements.
A detachable clevis links the free end of the pull to the inner wire of a push-pull control cable. A bracket anchors the cable housing to a rigid frame beside a straight run of the slide fastener, with the exposed wire aligned with the direction of slider travel. The elastic member seats in the coupling-column groove and retains the pull shaft as the pull pivots between the slider body and the clevis. A remote lever advances or retracts the wire to move the slider in either direction.
An assembly fixture locates the slider body by the lower blade plate, and an overhead camera measures the position and orientation of the groove in the coupling column. A robot places the pull shaft in its cradle on the upper blade plate, then a force-sensing press inserts the spring tongue into the groove while the spring spans the shaft. The controller compares the insertion force and travel with acceptance limits established from seated assemblies. A probe rotates the pull through a set angle, and a second image confirms that the shaft remains in the cradle.
The slider body contains 1.20 mass % magnesium, 0.65 mass % silicon, 0.30 mass % copper, and 0.15 mass % chromium, with aluminum as the balance apart from trace impurities. Solution heat treatment, quenching, and artificial aging increase hardness through precipitation.
A transverse groove in the coupling column receives the downturned tongue at the front of a stamped spring strip. The groove sidewalls locate the tongue, and the strip extends rearward over the pull shaft.
patent.fyi, US 2026/0354541 A1, claim 1, first published 2026-11-19T00:16:15-05:00, https://patent.fyi/US20260354541/, SHA-256 b0772660245644979c02a68b0b950ccc2bce314f0f5247637698441d50e3d722