Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
No entries.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Interchangeable drilling heads for woodworking
A bench-mounted motor accepts a reduction head for boring hardwood and a direct-drive head for drilling pilot holes. A cylindrical pilot locates each head in the motor housing, and a quarter-turn collar retains it. An axially sliding splined coupling transfers torque and radial loads across the shaft interface. Paired angular-contact bearings in each head carry bit thrust into the head housing and through the collar to the motor housing.
Component substitution
Needle roller bearings support the spindle
Two needle roller bearings replace the radial ball bearings in each interchangeable drill head, and opposed thrust ball bearings support the spindle axially. The needle roller bearings run on hardened spindle journals positioned on either side of the output gear. The thrust bearings sit between a spindle shoulder, a retaining nut, and opposing shoulders in the head housing. The motor shaft engages the head input shaft through a cylindrical pilot and sliding splines with clearance between the shaft ends.
Toothed belt drive in an offset head
A toothed belt and two pulleys replace the reduction gears in one interchangeable head and place the bit spindle parallel to the head input shaft. A 16-tooth pulley on the input shaft drives a 48-tooth pulley on the spindle, producing a 3:1 speed reduction. An eccentric idler sets belt tension, and paired angular-contact bearings support the spindle against belt tension and drilling thrust. A piloted sliding spline couples the motor shaft to the head input shaft, and a threaded collar secures the head housing to the motor housing.
Parameter or scale variation
Three heads span a sixfold speed range
A motor operating at 6,000 revolutions per minute accepts three drill heads with input-to-output speed ratios of 1:1, 3:1, and 6:1. The direct-drive head connects its input shaft to the bit spindle, and the other two heads use planetary gearsets with fixed ring gears and carrier outputs. The heads deliver nominal spindle speeds of 6,000, 2,000, and 1,000 revolutions per minute, respectively. A sliding spline at the motor interface provides 0.5 millimeters of axial end clearance after the housing latch seats, and opposed spindle bearings react drilling thrust in each head.
Combination with existing systems
Robotic drill with axial force feedback
A robot wrist carries the motor housing through a six-axis force and torque sensor mounted between the wrist flange and the housing. Each interchangeable head seats on a cylindrical pilot and locks to the motor housing with a collar, while a sliding spline drives the head input shaft. The head spindle bearings transfer drilling thrust through the head and motor housings to the wrist sensor. The robot controller projects the measured force onto the spindle axis and adjusts the feed rate to maintain the commanded axial force.
Automated or data-driven variant
Automatic speed selection from head identification
Each drill head carries a passive radio-frequency identification tag that stores its motor-to-spindle speed ratio and maximum spindle speed. A reader coil in the motor housing reads the tag when a position switch confirms that the head latch is closed. The controller limits the requested spindle speed to the stored maximum, multiplies the result by the speed ratio, and regulates motor speed using a shaft encoder. An axially sliding, radially piloted spline drives the head input shaft, and spindle thrust bearings react feed loads into the head housing.
Cite aspatent.fyi, US 2026/0354838 A1, claim 1, first published 2026-11-19T04:53:05-05:00, https://patent.fyi/US20260354838/, SHA-256 93c0f904f52530ff53924b1ca3b95626f8980c566d7b0687acfa3f0ed210edcd