Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
No entries.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Tube joining for irrigation dosing lines
Two grooved clamps hold flexible vinyl dosing tubes side by side on an irrigation service bench. Each tube passes between a conductive blade and a grooved anvil connected to a radio-frequency power supply. After both blades cut through the heated tubes and retract, a cross slide aligns the pump-side end of one tube with the manifold-side end of the other. An axial slide presses the molten ends together and holds them in contact during cooling.
Component substitution
Cartridge heated blades and anvils
Resistive cartridge heaters in metal blade holders and anvil blocks supply heat by conduction. A thermocouple near each cutting face feeds a temperature controller for the corresponding heater. Each blade closes against its anvil to deform and sever the softened tube, then retracts clear of the clamp travel path. A cross slide aligns the selected ends, and an axial actuator presses them together while the faces remain molten.
Parameter or scale variation
Scaled jaw inserts for two tube sizes
Interchangeable clamp inserts hold tubes with outside and inside diameters of 3 mm and 2 mm or 6 mm and 4 mm, respectively. Each cycle uses two tubes of the same size, and the centerlines of the 3 mm and 6 mm insert pairs are spaced 8 mm and 12 mm apart, respectively. The anvil grooves match the respective tube sizes, and a mechanical stop sets the transverse travel of the moving clamp to the corresponding centerline spacing. After radio-frequency heating and cutting, the moving clamp travels to that stop and then advances axially to join the molten ends.
Combination with existing systems
Tube joining in a gravimetric filling station
A bench-mounted joining head sits between a liquid supply pump and a receiving bag on a weighing platform, with slack tubing between the stationary clamp and the bag. The filling controller stops the pump and closes pinch valves on both lines before the joining head heats and cuts the tube ends. The head aligns and presses the selected ends together, then sends a ready signal after the cooling dwell and clamp release. The filling controller opens the pinch valves, restarts the pump, and stops it at the target bag mass.
Automated or data-driven variant
Camera guided alignment of molten tube ends
Two backlit cameras view the gap between the tube ends from perpendicular directions after the blades retract. Software fits centerlines to the tube silhouettes immediately behind each molten face and calculates the transverse offsets between the selected ends. A two-axis stage moves one clamp by the calculated offsets while the axial gap remains open. Once the measured offsets fall within the programmed tolerance, a separate axial actuator brings the molten faces into contact.
Force controlled joining of molten tube ends
A load cell sits between the axial actuator and the moving clamp, and a linear encoder measures clamp travel. After cutting and transverse alignment, the actuator advances until the load cell detects contact between the molten faces. The controller then regulates the axial force to a stored setpoint for the tube size and material, while the encoder limits further travel to a stored maximum compression distance. At the travel limit, the controller holds the clamp position until the cooling dwell ends.
Cite aspatent.fyi, US 2026/0355491 A1, claim 1, first published 2026-11-19T12:21:55-05:00, https://patent.fyi/US20260355491/, SHA-256 18f80258c6ee27f4c723abb7cb85f1c0939671eafb9fd66b8fb3cf8e0dd496ec