Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
No entries.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Aseptic transfer of beverage samples
A tank sample valve and a sealed sample bottle each carry a connector with a closed poppet. A clamp seats the connectors against an annular gasket and leaves a gap between the poppet faces. Steam enters through an upper chamber port and condensate drains through a lower port while both poppets remain closed. After the steam cycle and drainage, the chamber ports close and the poppets open to fill the bottle.
Component substitution
Diaphragm valves at the connection faces
Each connector uses a flush-face diaphragm valve in place of a sliding poppet to isolate its liquid passage. A perimeter gasket encloses the gap between the closed diaphragms when the connectors latch. Steam enters the gap through a side port and condensate leaves through a low drain port. After the steam cycle and drainage, the ports close and actuators lift both diaphragms from their seats to connect the liquid passages through the chamber.
Parameter or scale variation
Short gap for small liquid transfers
Two connectors have 2 mm liquid bores centered on opposed faces, and hard stops set a 0.5 mm gap when the latch closes. An annular gasket defines an 8 mm chamber diameter, which gives approximately 25 microliters of gap volume before port and face recesses are included. Steam enters through a radial port and condensate exits through a second port at the bottom while the liquid valves remain closed. After the steam cycle and drainage, both chamber ports close and the liquid valves open.
Four isolated channels in one coupling
Two clamp plates carry four opposed pairs of 3 mm liquid passages on 15 mm centers, with a normally closed liquid valve at each passage face. Four annular gaskets create separate chambers across a 1 mm face gap when the plates clamp together. A steam header feeds each chamber through its own inlet valve, and each chamber drains through a separately valved outlet. After steam exposure and drainage, the chamber ports close and each opposed liquid valve pair opens on demand.
Combination with existing systems
Sterile connection on a dialysis cart
A sterile replacement-fluid bag connects to the inlet of a dialysis cart's replacement-fluid pump through a latched connector pair. The latch compresses an annular gasket to enclose the gap between two closed valve faces. A temperature-controlled steam module feeds the chamber and drains condensate into a separate collection vessel. The cart enables the pump after the steam cycle finishes, the chamber drains and cools, and both liquid valves indicate open.
Automated or data-driven variant
Sensor interlocks for valve opening
A latch switch, a chamber pressure transducer, and a thermocouple near the condensate outlet feed a programmable controller. The controller verifies latch engagement and checks chamber pressure decay with the liquid valves closed before admitting steam. It starts the exposure timer when the outlet reaches the configured temperature and resets the timer if the temperature drops below that threshold. After the timed exposure, the controller drains the chamber and opens the liquid valves only after confirming that the steam and drain valves are closed and chamber pressure is within the configured transfer range.
Cite aspatent.fyi, US 2026/0355493 A1, claim 1, first published 2026-11-19T12:21:55-05:00, https://patent.fyi/US20260355493/, SHA-256 b7d4c37ef7ea6bc792156c2669113f501fe72634a7b0b5f08476450b0e61eb71