Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
1.1Dissolved carbon feed
What ifWhat if the feed system receives bicarbonate-bearing water and releases carbon dioxide inside the apparatus?
Claim language“receive a gas”
A metering pump feeds bicarbonate-bearing water to an acidification vessel, where a pH controller maintains the liquid below pH 4. A membrane contactor transfers the released carbon dioxide to a nitrogen carrier stream that flows through a downstream adsorbent bed.
1.2Carbon dioxide absorption in liquid
What ifWhat if a circulating liquid captures carbon dioxide by absorption?
Claim language“one or more adsorbent materials”
An aqueous amine solution flows down a packed tower while the feed gas rises through the packing. Carbon dioxide dissolves and reacts in the liquid, which a pump sends to a heated stripping column for regeneration.
1.2Selective membrane separation
What ifWhat if a membrane continuously transfers carbon dioxide from the feed into a separate gas stream?
Claim language“one or more adsorbent materials”
A compressor raises the pressure of a carbon dioxide and nitrogen feed before it enters a hollow-fiber module. Carbon dioxide permeates the polymer fiber walls faster than nitrogen under the partial-pressure difference, and a permeate header collects the enriched stream.
1.3Positive pressure steam sweep
What ifWhat if steam carries carbon dioxide out of the chamber at slightly above atmospheric pressure?
Claim language“a vacuum system”
A steam distributor passes low-pressure steam through a steam-compatible adsorbent bed and heats it to release carbon dioxide. A backpressure valve holds the chamber slightly above atmospheric pressure as the gas mixture flows to a condenser that removes water.
1.3Carbon dioxide extraction in water
What ifWhat if pressurized water carries desorbed carbon dioxide out of the chamber as dissolved inorganic carbon?
Claim language“a vacuum system”
A heated, flow-through regeneration vessel holds a water-compatible sorbent above its carbon dioxide desorption temperature. A pump circulates pressurized alkaline water through an internal gas-liquid membrane contactor, where released carbon dioxide transfers into the liquid and forms bicarbonate or carbonate. A liquid outlet carries the resulting solution out of the vessel.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Carbon dioxide removal from produce storage
A recirculation blower draws gas from a sealed produce storage room through a particulate filter and a chamber packed with supported solid amine pellets. The chamber adsorbs carbon dioxide released by the produce, and the blower returns treated gas to the room. During regeneration, shutoff valves isolate the chamber from the room, an electric jacket heats the bed, and a vacuum pump draws the released carbon dioxide into a separate receiver.
Component substitution
Steam purge for sorbent regeneration
A low-pressure steam sparger replaces the external chamber heater and distributes steam beneath a bed of steam-stable supported solid amine pellets. After the inlet and outlet valves close, steam flows through the bed and transfers heat directly to the pellets, releasing adsorbed carbon dioxide. The vacuum pump draws the vapor mixture through a chilled condenser and a condensate separator before delivering the carbon dioxide to a receiver.
Structured honeycomb in the adsorption chamber
A ceramic honeycomb with a porous solid amine coating replaces the loose adsorbent pellets in the capture chamber. A perimeter gasket seals the honeycomb against the chamber wall, and inlet and outlet plenums distribute feed gas through the open channels. After the gas valves close, electric resistance plates between short honeycomb blocks heat the coating, and a vacuum pump withdraws released carbon dioxide through the outlet plenum.
Parameter or scale variation
Benchtop bed with adjustable feed flow
A single chamber with a 50 mm internal diameter holds a 150 mm deep bed of supported solid amine pellets between perforated retainers. A mass flow controller feeds a test mixture containing 1 percent carbon dioxide in nitrogen at 1 to 3 standard liters per minute and approximately 1 bar absolute. After each adsorption run, shutoff valves isolate the chamber, an electric band heater raises the bed to 90 °C, and a vacuum pump holds the chamber at 20 kPa absolute during desorption.
Combination with existing systems
Captured carbon dioxide for greenhouse enrichment
An outdoor air intake feeds a chamber containing supported solid amine pellets, and the treated air vents outdoors. An electric heater regenerates the isolated bed, and a vacuum pump routes the released carbon dioxide through a condenser to a buffer vessel. A greenhouse dosing system meters gas from the buffer vessel into the recirculation duct when the greenhouse carbon dioxide monitor reads below its daytime setpoint and the ventilation vents are closed.
Automated or data-driven variant
Adaptive regeneration using exhaust flow measurements
A single adsorption chamber connects to an electric heater and a variable-speed vacuum pump through separate power and pressure controls. A condenser and condensate separator sit between the chamber and the pump, and a molar flow meter and an infrared carbon dioxide analyzer sample the pump discharge. A controller multiplies molar flow by the measured carbon dioxide mole fraction and integrates the result to track recovery during regeneration. The controller holds chamber pressure at its setpoint and ends regeneration when the carbon dioxide recovery rate stays below 5 percent of its peak for 60 seconds.
Specific version of a part
Direct exposure to wind
An open rack holds porous panels coated with an amine-functionalized sorbent. Wind moves air through the panel channels, where the sorbent binds carbon dioxide. A shuttle moves loaded panels into a sealed chamber for regeneration.
Filtered variable speed intake
A weather louver and pleated particulate filter sit upstream of a variable-speed centrifugal blower. A duct flow sensor supplies feedback to the blower controller to maintain the selected gas flow as filter pressure drop increases.
Amine coated honeycomb cartridge
A removable ceramic honeycomb carries a porous silica coating functionalized with primary amine groups. A perimeter gasket directs feed gas through the honeycomb channels, where carbon dioxide binds to the amine groups.
Indirect hot water regeneration
A closed water loop circulates through finned tubes embedded in an amine sorbent bed. A temperature controller holds the bed at 90 °C during desorption, and a vacuum pump withdraws the released carbon dioxide through a chamber outlet.
Dry screw vacuum extraction
A dry screw vacuum pump draws gas through a condenser and a condensate separator connected to the capture chamber outlet. A pressure transducer controls pump speed to maintain the selected absolute pressure during desorption.
Section 3 · quoted from USPTO records
Other work
Passages reproduced word for word from two earlier-published U.S. patent documents, placed beside the language of claim 1. No characterization is offered. Each passage is marked A or B for the document it comes from; ¶ numbers are the paragraph numbers in the USPTO’s published full text of that document.
1.1an air intake system configured to receive a gas comprising a carbonic substance;
More specifically, in FIG. 1, a feed 2 is shown entering a membrane unit 4, with carbon dioxide being removed in a permeate stream 8 and the treated natural gas going to a TSA unit 12 in line 10.
A · US 8,388,732 B2 · ¶ 14
1.2at least one carbon capture chamber fluidly connected to the air intake system, the at least one carbon capture chamber comprising one or more adsorbent materials, the one or more adsorbent materials configured to adsorb the carbonic substance from the gas; and
The natural gas stream is sent to a membrane unit on the ship, barge or platform to remove carbon dioxide and other impurities from the natural gas stream and to produce a partially purified natural gas stream.
A · US 8,388,732 B2 · ¶ 8
1.3a desorption system, the desorption system comprising: a system configured to remove the carbonic substance from the one or more adsorbent materials; and a vacuum system configured to extract the carbonic substance from the at least one carbon capture chamber.
The system is then filled with the desired heating gas (CO2 or 50% CO2 in nitrogen) which is circulated through the heated gas loop and the reaction chamber until the adsorbent bed has reached the desired temperature via convective heat transfer from the heating gas. The system is then evacuated under a given set of conditions to desorb the CO2 and regenerate the adsorbent.
B · US 11,654,393 B2 · ¶ 34
An empty cell means only that no passage was reproduced there.
Statements in these documents
There exists a need to develop an improved process or integrated processes that can remove carbon dioxide and moisture to meet FLNG requirements.
A · US 8,388,732 B2 · ¶ 7
The present invention provides a process of treating a natural gas stream comprising sending a natural gas stream to a ship, barge or platform that is carrying equipment for purification of natural gas.
A · US 8,388,732 B2 · ¶ 8
A common issue with solid sorbents, including zeolites, is their low thermal conductivity, which makes them difficult to heat for regeneration without using complex and expensive heat transfer systems.
B · US 11,654,393 B2 · ¶ 7
The use of CO2 as a heating medium allows efficient heating of the sorbent bed and enables high purity CO2 product.
B · US 11,654,393 B2 · ¶ 7
Cite aspatent.fyi, US 2026/0355674 A1, claim 1, first published 2026-11-19T14:02:27-05:00, https://patent.fyi/US20260355674/, SHA-256 0963e796b6724e2327b9f72299fc15a21c4f8b89f9f4d5c57f6095b69281037a