Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
No entries.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Refractory lining removal in foundries
A handheld chisel hammer uses a flat chisel to break spent refractory lining from a cooled foundry ladle. A front sliding guide supports the impact unit near the hammer mechanism, and a housing-mounted U-shaped rear rail captures a guide block attached to the motor carrier. An axial spring between the carrier and the housing compresses as the operator feeds the chisel into the lining and allows the impact unit to recoil along both guides.
Component substitution
Round shafts with plain bushings
Two hardened steel shafts replace the U-shaped rear rail and guide block, and their ends seat in bosses on the housing. Polymer-lined plain bushings in the motor carrier slide on the shafts, which run parallel to the front sliding guide and lie on opposite sides of the motor. The two shafts restrain rotation of the carrier while an axial spring between the housing and the impact unit accommodates recoil.
Elastomer rings for axial spring isolation
Two annular elastomer compression elements replace the axial decoupling spring and sit on opposite sides of a flange on the motor carrier. Axial shoulders in the housing preload both rings, and the front sliding guide and U-shaped rear rail carry transverse loads. Movement of the impact unit compresses one ring and unloads the other, producing a restoring force and dissipating energy through elastomer hysteresis. Spacers set the initial compression, and hard stops limit ring strain at both ends of travel.
Parameter or scale variation
Paired rear rails for a larger hammer
Two U-shaped rear rails mount parallel to the impact axis on opposite sides of the motor, with their guide centerlines 80 mm apart. Each rail engages a 35 mm long sliding block fixed to the motor carrier, and the rear guide provides 12 mm of total axial travel. The front sliding guide shares the same travel, and mechanical stops limit motion to 6 mm in either direction from the unloaded position. Two axial springs placed symmetrically between the housing and carrier share the feed load.
Combination with existing systems
Chisel hammer with local dust extraction
A dust shroud mounts to the nose of the outer housing and surrounds the chisel near the work surface. A flexible brush skirt follows surface irregularities, and a side port connects the shroud to a shop vacuum through a flexible hose. The front sliding guide and the U-shaped rear rail support the impact unit inside the housing, and an axial spring accommodates recoil. The shroud opening clears the tool holder and chisel through the full sliding travel.
Automated or data-driven variant
Motor control from measured guide travel
A linear Hall sensor mounts to the housing beside the U-shaped rear rail, and a magnet mounts to the sliding block on the motor carrier. The controller converts the sensor signal to axial position using calibration readings taken at the two travel stops. If the block stays within 1 mm of the rear stop for 100 ms, the controller reduces the motor speed command. After the block remains at least 3 mm from that stop for 200 ms, the controller ramps back to the trigger setting.
Cite aspatent.fyi, US 2026/0355921 A1, claim 1, first published 2026-11-19T16:57:22-05:00, https://patent.fyi/US20260355921/, SHA-256 257b0d94dbf843e83c7a9fbdded8f01f94976cc9d12b1934ef1456bd4f3aa161