Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
No entries.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Release liners for packaging chutes
A stainless steel chute liner carries a film with a fluoropolymer release face and a metal-facing layer of fluorinated ethylene propylene. An oven heats the liner above the melting point of the metal-facing layer, and a matched die presses the film against the hot steel as it forms the chute profile. Heat conducted from the steel melts the contact layer, and the die holds the assembly under pressure as the layer solidifies.
Component substitution
Polyamide contact layer on aluminum
A heat-stabilized polyamide 12 layer replaces the fluoropolymer blend at the metal interface of a silicone-faced release film. The polyamide layer faces a grit-blasted aluminum panel heated above the melting point of the polyamide. A flat press brings the layers together so that heat from the aluminum melts the polyamide and pressure drives it into the surface texture. The press holds the film against the panel until the polyamide solidifies.
Diaphragm pressing of curved panels
A pneumatic diaphragm press with a high-temperature silicone membrane replaces the rigid upper die for laminating a shallow curved aluminum panel. A contoured lower fixture supports the heated panel, and a perimeter frame holds the film with its thermoplastic contact layer facing the metal. Vacuum ports in the fixture evacuate air from beneath the film, and pressure behind the membrane presses the film into the panel contour while heat from the aluminum softens the contact layer. The fixture cools the assembly under diaphragm pressure until the contact layer sets.
Parameter or scale variation
Four panels in one press cycle
A four-pocket tool holds four 100 mm by 100 mm aluminum blanks, each 1.5 mm thick, and a locating frame centers a separate film patch over each blank with its fluorinated ethylene propylene contact layer facing the metal. A heater brings the blanks to 290 °C before loading, and the press closes while their surfaces remain above the melting point of the contact layer. Four floating pads apply a nominal pressure of 0.5 MPa to each assembly for 10 seconds while water-cooled tooling removes heat from the stack. The tool releases the panels when the contact layers solidify.
Combination with existing systems
Coil feed with indexed hot pressing
A coil-fed blanking line shears aluminum strip into blanks and transfers them through an induction heater to an indexed press. A separate unwind feeds release film through a cutter that places one patch above each heated blank with its thermoplastic contact layer down. The press closes while the metal surface is above the contact layer's melting point, and heat conducted from the blank melts the layer under pressure. A downstream trim station removes the film overhang after the bond sets.
Automated or data-driven variant
Temperature gated robotic film placement
A calibrated infrared camera reads a prepared high-emissivity spot on a sacrificial tab attached to the heated metal blank. A controller commands a vacuum gripper to place the film contact-side down when the measured temperature exceeds the contact layer's melting point by the programmed transfer margin. The controller closes the press and uses a load cell to regulate force while the substrate conducts heat into the film. The controller records the temperature and force trace for each blank and routes blanks with readings outside the programmed limits to a separate tray.
Cite aspatent.fyi, US 2026/0356085 A1, claim 1, first published 2026-11-19T19:49:30-05:00, https://patent.fyi/US20260356085/, SHA-256 639a3fb452bb8c118dbd99d0050b12f7df3563475d78561c48c4cd6a3090b1c4