Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
1.1Continuous feeder current control
What ifWhat if each charging apparatus regulates current from live feeder measurements without a charging schedule?
Claim language“a corresponding charging schedule”
A current transformer measures the load on each feeder phase, and a feeder controller broadcasts a current limit for each phase once per second. Each charging apparatus applies the limit for its connected phase through its pilot signal and reduces the pilot setting when the measured phase current approaches the feeder limit.
1.2Schedules stay in charging apparatus
What ifWhat if the controller sends each schedule only to the charging apparatus, and the EV receives only the current limit in force?
Claim language“the determined corresponding charging schedules to the first set of EVs”
Each charging apparatus stores its assigned time slots and current settings in local memory. At each slot boundary it updates the pilot duty cycle or disables charging, with no future slot information sent to the EV.
1.4Reserve current across the session
What ifWhat if the controller admits charging sessions against a fixed current budget without forecasting a load curve?
Claim language“forecasting an expected load curve”
For each phase, a controller stores a current budget and a single running total of reserved current. It reserves the requested current for the entire session when the reservation fits within the budget, and releases it when the charging apparatus reports that the session ends.
1.5Committed slots stay fixed
What ifWhat if the controller places every incoming session into unused capacity while keeping all previously allocated slots fixed?
Claim language“determining whether to modify the determined corresponding charging schedule”
A table stores the remaining power allowance in each five-minute slot after earlier sessions are booked. The controller fills the new session from slots with the most spare power before its departure time and reports the energy it can allocate if the request exceeds available capacity.
1.5Allocate the earliest feasible slots
What ifWhat if the additional EV receives the earliest feasible slots under a fixed power ceiling, without selecting slots to flatten the expected load curve?
Claim language“determining the charging schedule for the additional EV to optimize the expected load curve”
The controller scans five-minute slots in chronological order and assigns power up to the lower of the vehicle's charging limit and the headroom in each slot. The scan ends when the requested energy is allocated or the departure time is reached.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Shore charging for harbor ferries
A harbor charging controller groups electric ferries by the transformer that supplies their berth chargers. When a ferry connects, the controller reads its departure time, requested energy, and charger power limit, then adds a candidate schedule to the charging schedules at the other berths. If the combined forecast exceeds the transformer limit, the controller shifts charging for ferries with spare time before departure and sends the resulting schedules to the affected berth chargers.
Component substitution
Charging schedules using minimum cost flow
A minimum cost flow solver replaces the load-curve optimization routine in the charging controller. The solver links each connected vehicle to the time slots before its departure and caps each link at the energy its charger delivers in one slot. Each time slot connects to a common sink through capacity bands with increasing per-unit costs, so allocating more energy to a heavily loaded slot costs more. On a plug-in event, the controller solves the flow problem for the new vehicle and the connected vehicles with flexible schedules, then sends schedules derived from the resulting slot allocations.
Parameter or scale variation
Thirty minute scheduling for timed stops
A charging controller assigns 12 charge points to a group with a 300 kW charging allocation and limits each charger to 60 kW. The controller represents the next 30 minutes as 120 slots of 15 seconds each. On each plug-in event, it sums scheduled power by slot and recalculates the new session and selected active sessions subject to the group limit, individual charger limits, and departure times. The controller sends each affected charger its timestamped setpoints and holds the current setpoints until the next slot boundary.
Charging schedules with phase current limits
A controller records the supply phase of each of 18 single-phase charge points on a three-phase feeder with a charging allocation of 80 A per phase. Each charge point accepts setpoints from 6 A through 32 A in 1 A steps, plus a pause command. On each plug-in event, the controller sums scheduled current separately for each phase in one-minute slots and recalculates the new session and selected active sessions. It sends the resulting current setpoints to the affected charge points while keeping every phase within its allocation.
Combination with existing systems
Charging coordination with building demand control
A charging controller and a building energy management system share a meter at the building service entrance. The building system publishes the charging power available in each future slot after reserving capacity for ventilation and cooling equipment. When a vehicle connects, the charging controller sums the station schedules and revises selected sessions to fit the published limits. The building system updates those limits when equipment schedules change, and the charging controller recalculates the affected sessions.
Automated or data-driven variant
Charging forecasts from measured power taper
Each charger reports its requested current limit, measured charging power, and cumulative energy delivered to a controller. The controller fits a piecewise linear power curve for each session from measurements collected while the vehicle draws below the requested limit. On a plug-in event, it forecasts existing sessions using the fitted curves and uses the new vehicle's reported charging limit for its initial forecast. It schedules the new session and shifts selected existing sessions within their departure windows using the summed forecast.
Specific version of a part
Driver registers each charging session
The driver selects a port, enters the requested energy and departure time, and presses a start button that submits the request to the scheduling controller. The charging apparatus uses a local pilot interlock to prevent energization until the connector is seated and the vehicle is ready.
Departure based charging slots
A controller takes the requested energy, departure time and maximum charging power for each vehicle. It assigns charging power in five-minute slots so that each vehicle receives its requested energy by departure and the combined power stays below the transformer limit.
Time stamped schedule delivery
The controller sends each EV a schedule through its connected charging apparatus over a bidirectional link on the charging cable. The schedule contains slot start times, durations and power limits, and the EV acknowledges the schedule identifier.
Pilot voltage insertion detection
The charging apparatus measures the pilot voltage and reports the transition from the disconnected state to the vehicle-present state. The controller maps the reported port identifier to the transformer that serves the port and registers the EV as an additional session.
Peak minimization with selective updates
The controller first calculates the lowest predicted peak with existing schedules fixed, then repeats the calculation with flexible time slots unlocked for vehicles that are already connected. If the second calculation lowers the peak, the controller sends the resulting schedule to the arriving EV and sends revisions only to vehicles whose slots change.
Section 3 · quoted from USPTO records
Other work
Passages reproduced word for word from two earlier-published U.S. patent documents, placed beside the language of claim 1. No characterization is offered. Each passage is marked A or B for the document it comes from; ¶ numbers are the paragraph numbers in the USPTO’s published full text of that document.
1.1determining, by one or more processors for a first set of one or more electric vehicles (EVs) of a group of a plurality of EVs, a corresponding charging schedule for charging by an electrical distribution network resource through a corresponding charging apparatus;
To calculate the minimum system capacity, SCH(V, Ucap, ) is solved for optimal charging rates r*, for each day in the data-set where V is the set of all EVs using the charging system in a day,
A · US 2020/0254896 A1 · ¶ 69
The charging plan is created for each storage battery 21, that is, for each user. In the embodiment, storage battery 21 of each traveling object 2 is charged during a time period specified by the corresponding charging plan at charging facility 3 specified by the corresponding charging plan.
B · US 2024/0001795 A1 · ¶ 71
1.2providing by the one or more processors the determined corresponding charging schedules to the first set of EVs;
In several embodiments, systems and methods for adaptive EV charging can be utilized to collect data from electric vehicle supply equipment (EVSEs) or charging stations, aggregate the collected data in a cloud based system, analyze the collected data to arrive at new charging processes, and then push out the new charging processes to the EV chargers.
A · US 2020/0254896 A1 · ¶ 42
1.3subsequent to providing the corresponding charging schedules for the first set of EVs, detecting by the one or more processors an additional EV of the group plugging in for charging by the electrical distribution network resource through a corresponding charging apparatus;
Electric vehicles 118 can connect to the charging station and request charging.
A · US 2020/0254896 A1 · ¶ 43
1.4in response to detecting the additional EV plugging in for charging, determining by the one or more processors a corresponding charging schedule for subsequently charging the additional EV, including: forecasting an expected load curve for power drawn by a sum of the charging schedule for the additional EV and the previously determined corresponding charging schedules for the one or more EVs of the group plugged in for charging;
It should be noted that after obtainer 11 obtains the reservation information, predictor 12 predicts the charging demand on the further basis of the reservation information. It should be noted that by referring to the reservation information, predictor 12 can recognize future charging demand during the specified time period.
B · US 2024/0001795 A1 · ¶ 70
1.5in response to detecting the additional EV plugging in for charging, determining by the one or more processors a corresponding charging schedule for subsequently charging the additional EV, including: determining the charging schedule for the additional EV to optimize the expected load curve, including: determining whether to modify the determined corresponding charging schedule for one or more EVs of the first set; and in response to determining to modify the corresponding charging schedule for one or more selected EVs of the first set, determining a corresponding updated charging schedules for the selected EVs of the first set; and providing by the one or more processors the determined corresponding charging schedule to the additional EV and the determined corresponding updated charging schedule to the selected EVs of the first set.
In a further additional embodiment, an adaptive electric vehicle charging platform includes: a processor; a memory containing: an adaptive EV charging application; a plurality of EV charging parameters; wherein the processor is configured by the adaptive EV charging application to: collect the plurality of EV charging parameters from one or more EVSEs, simulate EV charging control routines and push out updated EV charging control routines to the one or more EVSEs; and wherein
A · US 2020/0254896 A1 · ¶ 18
An empty cell means only that no passage was reproduced there.
Statements in these documents
When the sun is shining, solar floods the market and then drops off as electricity demand peaks in the evening.
A · US 2020/0254896 A1 · ¶ 6
The present disclosure aims to provide a charging management method, a recording medium, and a charging management system that facilitate leveling of the charging demand of at least one charging facility.
B · US 2024/0001795 A1 · ¶ 7
In the creating, a charging plan for charging the storage battery to keep the charging demand less than or equal to a predetermined value is created based on the charging demand predicted in the predicting.
B · US 2024/0001795 A1 · ¶ 8
Cite aspatent.fyi, US 2026/0356237 A1, claim 1, first published 2026-11-19T22:39:24-05:00, https://patent.fyi/US20260356237/, SHA-256 193dadff861ecf93ff45ab78f86d7afd35c7a39c9e56bad4aa14384075863513