Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
1.1Free distance along the lane
What ifWhat if the longitudinal controller received only the confirmed free distance along the lane?
Claim language“describing at least one other motor vehicle”
A scanning range sensor marks each sampled cell along the projected lane as free, occupied, or unknown. The controller receives only the distance to the end of the contiguous free segment and limits speed so the stopping distance fits inside that segment.
1.2Queue detection from radar speeds
What ifWhat if the controller detected slow traffic ahead from vehicle speeds and spacing?
Forward radar tracks the longitudinal positions and relative speeds of vehicles in the host lane. The controller flags a queue when two consecutive tracks report ground speeds below 15 km/h and a separation below 30 m for at least one second.
1.3Multiplicative trigger time adjustment
What ifWhat if hazard lamp activation caused the controller to multiply the trigger time limit by a factor derived from closing speed?
Claim language“by a predetermined time interval”
The controller selects a base time limit from a road speed table and a multiplier from a closing speed table. Each update computes the product from the base limit, so the change in seconds varies with both inputs.
1.3Stopping distance in meters
What ifWhat if hazard lamp activation triggered a spatial stopping check?
Claim language“increasing a time difference value”
The controller calculates the distance needed to reduce host speed to lead speed at a calibrated deceleration and adds a three-meter clearance. When the lamps flash and measured range falls below that distance, the controller requests braking.
1.4Gap error drives braking
What ifWhat if the assistance system set braking demand from a fixed clearance target and the measured closing speed?
Claim language“in consideration of the increased time difference value”
Radar supplies the longitudinal gap and closing speed for the lead vehicle. The controller combines the gap error relative to a 12 m target with the closing speed, then limits the resulting deceleration request and its rate of change.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Hazard response on airport service roads
An airport baggage tractor carries a forward camera and a ranging radar, and its controller uses a service road map to identify vehicles on its planned route. The controller applies a recurring, synchronized flash criterion to the left and right rear lamps of each tracked vehicle. A positive detection adds a fixed interval to the maximum trigger lead time before a predicted collision on the route. The tractor applies the increased lead time to its longitudinal assistance function.
Component substitution
Photodiode array for lamp detection
A baffled silicon photodiode array replaces the forward camera used for lamp sensing, and a separate radar supplies vehicle tracks. The controller projects each track's angular position onto the calibrated array and selects channels on either side of the track center. It detects hazard flashing when both channels show repeated synchronized intensity transitions above their local background levels. A positive detection adds a fixed interval to the maximum trigger lead time before a predicted collision.
Parameter or scale variation
Fixed extension across multiple vehicle tracks
The controller monitors up to six forward vehicle tracks within 120 metres and samples their rear lamp states at 30 frames per second. It records a positive hazard detection after two paired flashes with left and right rising edges within 100 milliseconds of each other. If any vehicle in the predicted travel corridor meets the criterion, the controller increases the maximum trigger lead time from 1.5 seconds to 2.25 seconds. It applies the 0.75-second increase once per evaluation cycle, regardless of the number of positive tracks.
Combination with existing systems
Integration with an electronic horizon
A map-based electronic horizon provides the lane path and curvature ahead of the host vehicle. The assistance controller projects camera and radar tracks onto that path and applies the hazard flash criterion to vehicles aligned with it. A positive detection adds a fixed interval to the maximum trigger lead time. The controller compares that lead time with the collision time predicted along the curved path to trigger the assistance function.
Hazard timing with vehicle status broadcasts
A short-range radio receiver supplies time-stamped hazard switch status, position, and heading from equipped vehicles ahead. The controller associates each fresh broadcast with a forward radar track using position and heading tolerances. It treats an asserted hazard switch status from a uniquely associated broadcast as a positive detection and uses optical flash detection for tracks without an associated fresh broadcast. A positive detection from either source adds the same fixed interval to the maximum trigger lead time.
Automated or data-driven variant
Temporal model for rear lamp classification
A vehicle tracker extracts time-stamped image crops around each rear lamp and aligns each sequence to its vehicle track. A temporal convolutional network processes the paired sequences and estimates the probability of synchronized hazard flashing from training clips labeled as hazard flashing, one-sided signaling, steady illumination, or reflected light. The controller declares an active hazard signal when the probability exceeds a calibrated threshold over two consecutive evaluation windows. A positive result adds a fixed interval to the maximum trigger lead time used by the longitudinal assistance controller.
Specific version of a part
Direct switch status broadcast
The lead vehicle broadcasts a one-bit hazard lamp command state together with its position, heading, and message timestamp. The receiving vehicle matches the position and heading to its lane and uses the state bit from a current message.
Radar range and speed tracks
A forward radar reports range, azimuth, and radial speed for each tracked vehicle. The processor projects each track into the host vehicle's path and supplies the nearest in-path track to the assistance controller.
Synchronized rear lamp detection
A forward camera measures brightness in two tracked rear lamp regions at 30 frames per second. The detector reports active hazard lamps when both regions brighten and dim together through two successive flash cycles.
Half second trigger extension
The controller stores a normal maximum trigger lead time of 2.0 s. When the hazard lamp state is active, the controller adds a stored interval of 0.5 s to the normal value and uses 2.5 s as the maximum lead time.
Brake trigger threshold comparison
For a closing target, the controller estimates time to collision by dividing the measured gap by the positive closing speed. It requests braking when the estimate reaches or falls below the increased time limit.
Section 3 · quoted from USPTO records
Other work
Passages reproduced word for word from two earlier-published U.S. patent documents, placed beside the language of claim 1. No characterization is offered. Each passage is marked A or B for the document it comes from; ¶ numbers are the paragraph numbers in the USPTO’s published full text of that document.
1.1providing sensor information describing at least one other motor vehicle located in front of the motor vehicle in a direction of travel of the motor vehicle;
As will be described below, method 100 collects following distance measurements for the closest in-path vehicle (CIPV) ahead of the host vehicle as measured by one or more of the forward sensing systems 20 on the vehicle.
A · US 2015/0203108 A1 · ¶ 22
The EOCM 12 communicates with a plurality of sensors 14 in the vehicle that are adapted to detect the presence of an object, such as another vehicle, in front of the vehicle.
B · US 10,953,895 B2 · ¶ 30
1.2determining hazard warning light information which describes whether the at least one other motor vehicle has an activated hazard warning light or not, by applying a hazard warning light detection criterion to the provided sensor information;
1.3when, according to the determined hazard warning light information, the at least one other motor vehicle has the activated hazard warning light, increasing a time difference value, which describes a time difference that lies at most between a triggering time of a function of the driver assistance system and a collision time of a predicted collision of the motor vehicle with an obstacle in the surroundings of the motor vehicle, by a predetermined time interval; and
According to another aspect of the present disclosure, modifying a first pre-determined time to collision threshold based on information from the driver monitoring system and creating a first modified time to collision threshold and modifying a second pre-determined time to collision threshold based on information from the driver monitoring system and creating a second modified time to collision threshold further includes, modifying the first and second pre-determined time to
B · US 10,953,895 B2 · ¶ 22
1.4operating the driver assistance system in consideration of the increased time difference value.
That is stopping distances and time gaps would be increased, or a forward collision warning could be issued earlier, as a result of potential driver inattentiveness.
A · US 2015/0203108 A1 · ¶ 37
A method of providing a collision warning within a vehicle comprises detecting an object and determining the distance to the object, identifying when a driver is distracted and measuring the time that the driver has been distracted, calculating an actual time to collision, modifying first and second pre-determined time to collision thresholds based on information from the driver monitoring system and creating first and second modified time to collision thresholds, comparing t
B · US 10,953,895 B2 · abstract
An empty cell means only that no passage was reproduced there.
Statements in these documents
Accordingly, there is a need and desire for a driver assistance system and method that are tunable for a specific driver of the vehicle.
A · US 2015/0203108 A1 · ¶ 5
In one embodiment, the at least one driver assistance feature comprises at least one of an adaptive cruise control feature, an adaptive cruise control with stop and go feature or a forward collision warning feature.
A · US 2015/0203108 A1 · ¶ 8
The present disclosure relates to a system in an automotive vehicle that monitors the distance between the vehicle and an object in front of the vehicle and provides a warning to the driver of the vehicle based on the time it will take for the vehicle to collide with the object.
B · US 10,953,895 B2 · ¶ 1
Thus, while current systems achieve their intended purpose, there is a need for a new and improved system and method that will detect when a driver is distracted, evaluate how severely distracted the driver is, and adjust pre-determined TTC times based on the driver being distracted.
B · US 10,953,895 B2 · ¶ 4
Cite aspatent.fyi, US 2026/0356360 A1, claim 1, first published 2026-11-20T00:27:46-05:00, https://patent.fyi/US20260356360/, SHA-256 758b0b0d079badeea9354e8b1890fe53b17b0ca13633d1be590eea5b63cb9fdd