Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
1.1Continuous following gap control
What ifWhat if the controller regulated the following gap continuously?
A forward radar measures the gap and relative speed, and the controller computes a target gap from host speed and a time headway setting. At each update, gap error and relative speed feed an acceleration command that the actuator controller tracks with drive torque and braking.
1.2Regenerative speed reduction
What ifWhat if each speed reduction phase used active braking?
Claim language“a coasting control of causing the host vehicle to coast”
With the lane ahead clear, the controller commands positive motor torque until host speed reaches the upper limit. It then commands negative motor torque down to the lower limit, blends in friction braking when needed, and resumes positive torque.
1.3Relative speed cycling
What ifWhat if the following controller cycled between relative speed thresholds and used the measured gap to set a closing speed limit?
Claim language“maintained within a predetermined distance range”
Radar supplies the measured gap and the speed difference. The controller powers up to a closing speed limit computed from the measured gap, then coasts until the host travels slightly slower than the lead vehicle. A braking controller monitors stopping margin and takes over if the host needs to decelerate sooner.
1.4Automatic assistance level selection
What ifWhat if a supervisory controller selected the assistance level from sensor and actuator status?
Claim language“set by an operator of the host vehicle”
The supervisor reads forward sensor health, brake actuator availability, and host speed. It assigns an assistance level through a lookup table and requires a stable qualifying state for two seconds before raising the level.
1.7Following eligibility by track quality
What ifWhat if radar track quality alone determined whether a following request could start intermittent distance control?
Claim language“the driving assistance level is set to a predetermined level or less”
The controller accepts a following request after the radar maintains a confirmed lead track for ten consecutive updates and its range uncertainty falls below a calibrated limit. A stale or uncertain track blocks activation and returns an unavailable status to the display.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Intermittent travel for airport baggage tractors
An electric baggage tractor carries a wheel speed sensor and a forward radar that tracks vehicles in its travel lane. The controller alternates motor torque and coasting within a speed band on a clear service road and within a gap band when following another tractor. A cab selector sets the assistance level, with narrower speed and gap bands at the lower level. The controller checks the selected level against a minimum setting before starting intermittent gap control.
Component substitution
Electric axle replaces engine propulsion
A permanent magnet synchronous motor, inverter, and fixed reduction gear replace an engine and transmission as the longitudinal actuator. In the powering phase, the inverter applies positive motor torque and ramps it to zero at the transition to coasting. In the coasting phase, closed-loop torque control compensates for motor drag so that net axle torque is approximately zero. The supervisory controller uses vehicle speed on a clear road and measured gap when following, with switching bands selected by the operator's assistance level.
Stereo cameras replace forward ranging radar
Two synchronized forward cameras replace the radar used to detect and range the preceding vehicle. The processor rectifies the images, associates vehicle detections with the host lane, and calculates range from disparity, focal length, and camera separation. A tracking filter estimates closing speed from successive range measurements and supplies both values to the intermittent controller. Intermittent gap control starts only when the track meets the confidence threshold and the selected assistance level permits it.
Parameter or scale variation
Two band settings for depot lanes
A depot carrier stores a 9 to 11 km/h speed band and a 10 to 12 m following band at assistance level two. At level three, the respective bands widen to 8 to 12 km/h and 9 to 13 m. The controller updates speed and gap measurements every 50 ms and uses relative speed to predict where the gap will cross a band edge before switching between powering and coasting. Intermittent gap control starts only at levels two and three.
Combination with existing systems
Intermittent control with emergency braking
A longitudinal command arbiter connects the intermittent travel controller and an automatic emergency braking controller to the propulsion and brake actuators. The braking controller estimates collision risk from forward range and closing speed, and the arbiter gives its braking request priority over powering and coasting commands. During braking, the intermittent controller clears its current phase. After the braking controller releases its request, intermittent travel requires driver acknowledgment and a fresh check of the selected assistance level.
Automated or data-driven variant
Switch timing based on road grade
A controller combines wheel speed, longitudinal acceleration, and measured axle torque to estimate road grade and update a coast-down model. During coasting, it projects vehicle speed and, when a lead vehicle is tracked, projects the gap using measured relative speed. If the projection crosses a band edge within the actuator response time, the controller advances a phase change that brings the projected value back toward the band. The assistance level selects the band widths and determines whether intermittent gap control is available.
Specific version of a part
Level dependent torque slew
The speed and following controllers compute their upper and lower thresholds from target speed and following time. A torque rate limiter applies a lower positive slew rate at the first level and a higher positive slew rate at the second level.
Speed thresholds with hysteresis
The controller estimates host speed from wheel speed sensors and commands positive drive torque at 2 kilometers per hour below the set speed. At 2 kilometers per hour above the set speed, it commands zero net wheel torque and holds the coast state until the lower threshold is reached.
Radar based gap switching
Forward radar measures the gap, and the controller uses a distance band from 27 to 33 meters at a selected operating point. At the upper limit it commands positive drive torque to close the gap, and at the lower limit it switches to coasting so the gap opens as the host slows.
Steering wheel level selector
Two steering wheel buttons raise or lower the assistance level through three settings. The control unit debounces each press, stores the selected setting, and sends the current value to the instrument display.
Two calibrated control bands
At the first level, the controller uses a speed band of plus or minus 1 kilometer per hour and a distance band of plus or minus 2 meters around their respective targets. At the second level, it uses plus or minus 3 kilometers per hour and plus or minus 5 meters around the same targets.
Section 3 · quoted from USPTO records
Other work
Passages reproduced word for word from two earlier-published U.S. patent documents, placed beside the language of claim 1. No characterization is offered. Each passage is marked A or B for the document it comes from; ¶ numbers are the paragraph numbers in the USPTO’s published full text of that document.
1.1the intermittent travel control including an intermittent vehicle speed control and an intermittent inter-vehicle distance control,
Specifically, the advanced driver assist ECU 22 control functions such as a cruise control function to control acceleration and deceleration so that the vehicle follows the preceding vehicle while responding to changes in vehicle speed of the preceding vehicle and a lane tracing assist function to warn of the possibility of deviation from the lane or course and assist in part of the steering wheel operation to avoid deviation from the lane or course.
B · US 2024/0262378 A1 · ¶ 47
1.2the intermittent vehicle speed control being a control of driving the host vehicle by autonomously and alternately repeating a powering control of causing the host vehicle to travel by a driving force and a coasting control of causing the host vehicle to coast such that a travel speed of the host vehicle is maintained within a predetermined vehicle speed range when a preceding vehicle does not exist,
The pulse and glide is a driving method in which acceleration and coasting are repeated in order to reduce fuel consumption during traveling. In the eco-drive cruise control, the pulse and glide is performed so that the speed is within a predetermined allowable range up to a preset speed as an upper limit.
B · US 2024/0262378 A1 · ¶ 47
1.3the intermittent inter-vehicle distance control being a control of driving the host vehicle by autonomously and alternately repeating the powering control and the coasting control such that an inter-vehicle distance between the host vehicle and the preceding vehicle is maintained within a predetermined distance range when the preceding vehicle exists,
More specifically, from a viewpoint of adjusting an inter-vehicle distance between the host vehicle a and a preceding vehicle β to a predetermined target inter-vehicle distance, the controller 20 operates the actuator 5 to execute following control of adjusting a difference between the host vehicle speed Va and a vehicle speed of the preceding vehicle β (hereinafter also referred to as a “preceding vehicle speed Vβ”).
A · US 2023/0347891 A1 · ¶ 38
1.4a driving assistance level for the host vehicle by the intermittent travel control being set by an operator of the host vehicle,
1.5wherein the electronic control unit is configured to:
1.6when the driving assistance level is set to a first level, set the predetermined vehicle speed range and the predetermined distance range to narrower ranges as compared with when the driving assistance level is set to a second level higher than the first level; and
1.7not execute the intermittent inter-vehicle distance control when execution of the intermittent inter-vehicle distance control is requested and the driving assistance level is set to a predetermined level or less.
An empty cell means only that no passage was reproduced there.
Statements in these documents
When stopping the host vehicle based on the driving support control in JP2015-147525A, it is assumed that there is a possibility that, depending on a stop position, other vehicles are prevented from departing from the intersection and the other vehicles are left in the intersection.
A · US 2023/0347891 A1 · ¶ 3
In view of such circumstances, an object of the present invention is to provide an autonomous driving control method and an autonomous driving control device that can suppress other vehicles from being left in an intersection, in particular, in a crossing lane in which a traveling road, a line, a sidewalk, or the like intersects with a traveling road on which a host vehicle travels.
A · US 2023/0347891 A1 · ¶ 4
The technique disclosed in JP 2021-109582 A allows an occupant to recognize that the driver assistance is being performed but does not allow the occupant to recognize the state of the driver assistance being performed.
B · US 2024/0262378 A1 · ¶ 4
The present disclosure provides a vehicle display device, a vehicle display method, and a non-transitory storage medium that allow an occupant to recognize not only whether driver assistance is being performed but also the state of the driver assistance.
B · US 2024/0262378 A1 · ¶ 5
Cite aspatent.fyi, US 2026/0356361 A1, claim 1, first published 2026-11-20T00:27:46-05:00, https://patent.fyi/US20260356361/, SHA-256 77ba7858d941fded7e57fe6f8e5154191393a65bb3aac55684bbf0bbefa333c6