Questions about how individual parts of claim 1 might be changed. A question may describe something different from what the claim language recites, or a version of it; no view is offered on which.
No entries.
Section 2 · machine-generated
Variations
Further arrangements of the same subject matter, described here as of the publication date at the foot of this page.
Other field of use
Parked steering hold for marine helm
An electronic helm on a docked vessel uses a wheel angle encoder, a shaft torque sensor and a feedback motor coupled to the helm shaft. When berth mode engages, the helm controller stores the current wheel angle and suspends wheel-derived commands to the rudder actuator. When the shaft sensor detects applied torque, the feedback motor generates opposing torque and returns the wheel to the stored angle after release.
Component substitution
Optical twist sensing on the steering shaft
Two absolute optical encoders replace a strain-gauge torque transducer and measure the angles at opposite ends of a calibrated torsion bar. The controller stores the handle-side angle when park engages and calculates applied torque by multiplying the zero-corrected angular difference by the bar stiffness. A motor coupled to the output end of the bar applies opposing torque, and the handle-side encoder provides feedback for return to the stored angle.
Belt driven steering hold actuator
A brushless motor mounted beside the steering column drives the handle shaft through a toothed belt and a 3-to-1 reduction in place of a coaxial direct-drive motor. A shaft encoder records the starting angle at park entry, and a torque sensor between the handle and the driven pulley measures applied torque. The controller sets motor current to oppose the measured torque and uses the shaft encoder to return the handle to the stored angle after release.
Parameter or scale variation
Low torque hold for compact controls
A 160 mm diameter steering handle uses an angle encoder, a torque sensor and a direct-drive motor rated for 1.0 N·m of peak torque. At park entry, the controller captures the handle angle and samples shaft torque at 200 Hz. An applied torque above 0.12 N·m for 25 ms activates a 0.8 N·m maximum opposing torque, which the controller then uses to return the handle to within 1 degree of the stored angle after release.
Combination with existing systems
Steering hold linked to parking brake
A steer-by-wire controller receives verified clamp status from an electric parking brake controller over the vehicle data bus. When clamp status is confirmed and vehicle speed is zero, the steering controller stores the handle angle and enables parked torque monitoring. A handle motor counters detected torque while the clamp remains confirmed, and the controller ramps the hold torque to zero when it receives a parking brake release request.
Automated or data-driven variant
Temperature compensated parked torque detection
A controller stores the handle angle at park entry and reads a temperature sensor mounted beside the steering shaft torque sensor. It uses a calibration table measured at zero applied torque to interpolate and subtract the torque sensor offset at the current temperature. When the corrected torque exceeds the detection threshold, the motor opposes the applied torque, and an angle feedback loop returns the handle to the stored angle after release.
Cite aspatent.fyi, US 2026/0356424 A1, claim 1, first published 2026-11-20T01:05:32-05:00, https://patent.fyi/US20260356424/, SHA-256 5a373c67b0c79459afadb84f5e39134efa9ba4ac410ef4ea80b8924a1b8c16b2